Invacare BUZZ HMV Manuel d'utilisateur télécharger pdf (Page 43)

Part No. 1118395 43

TRANSPORTING THE SCOOTER (FIGURE 1)

DISASSEMBLING

1. If installed on scooter, remove the front basket. Refer to REMOVING/INSTALLING

THE FRONT BASKET in SECTION 10 of this manual.

2. Remove the seat. Refer to REMOVING/INSTALLING THE SEAT in SECTION 4 of

this manual.

3. Remove the rear shroud. Refer to REMOVING/INSTALLING THE REAR SHROUD

in SECTION 7 of the manual.

4. Remove the batteries. Refer to REPLACING THE BATTERIES in SECTION 8 of this

manual.

5. Fold tiller down to lowest locked position. Refer to TILLER ANGLE ADJUSTMENT

in SECTION 6 of this manual.

ASSEMBLING

1. Unfold tiller. Refer to TILLER ANGLE ADJUSTMENT in SECTION 6 of this manual.

2. Install the batteries. Refer to REPLACING THE BATTERIES in SECTION 8 of this

manual.

3. Install the rear shroud. Refer to REMOVING/INSTALLING THE REAR SHROUD in

SECTION 7 of the manual.

4. Install the seat. Refer to REMOVING/INSTALLING THE SEAT in SECTION 4 of this

manual.

5. If desired, install the front basket. Refer to REMOVING/INSTALLING THE FRONT

BASKET in SECTION 10 of this manual.

SECTION 9TRANSPORTING

TRANSPORTING

Section 9 - Transporting - includes the following:

Transporting the Scooter

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure that

all attaching hardware is tightened securely; otherwise serious injury or

damage may result.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 51 52

Pas de commentaire

Invacare BUZZ HMV Manuel d'utilisateur Page 43