Invacare 1085144 Manuel d'utilisateur télécharger pdf

1. Secure the frame to the floor with the suction cups or by

standing on the frame base during removal of the seat.

2. Press the UP button on the pendant to raise the

seat all the way up (DETAIL "A").

3. Grasp the handgrip on the battery pack and pull

upwards to remove it from the motor shroud as

shown in DETAIL "B".

4. Press and hold the spring loaded chair release

button to release the seat (DETAIL "C").

5. While holding the button with one hand, grasp the

seat bottom firmly with your other hand.

6. Slide the seat up until the slide block disengages from

the groove in the frame as shown in FIGURE 1.

7. Grasp the handgrip on the battery pack and push

downwards to install onto the motor shroud.

8. Press the DOWN button on the pendant to lower

the bath lift to the lowest position (DETAIL "A").

9. If necessary, remove the bath lift frame from the

bathtub. Refer to

REMOVING THE FRAME FROM

THE BATHTUB in this instruction sheet.

FIGURE 1 - REMOVING THE SEAT

Frame

Groove

Seat Bottom

Slide

Block

LIFT THE SEAT

STEPS 5-6

Down Button

Button

Pendant

DETAIL "A"

STEPS 1 AND 8

PULL UP TO REMOVE

PUSH DOWN TO

INSTALL

Battery Pack

DETAIL "B"

STEPS 2 AND 7

Motor

Shroud

Handgrip

Spring Loaded Chair Release Button

Recess

Seat

DETAIL "C"

STEP 4

NOTE: Check all parts for shipping damage. In case of dam-

age, DO NOT use. Contact your Dealer for further instruction.

SAFETY SUMMARY

The following recommendations are made for the

safe replacement of the PENDANT/CABLE/CUR-

RENT LIMIT DEVICE:

GENERAL WARNINGS

DO NOT install or use this equipment without

first reading and understanding this instruc-

tion sheet. If you are unable to understand

the Warnings, Cautions or Instructions in this

Instruction Sheet and in the Owner's Operat-

ing and Maintenance Manual (Part No.

1081003) provided with the Bath Lift, contact

a healthcare professional, dealer or techni-

cal personnel before attempting to install this

kit, otherwise, injury or damage may occur.

This kit MUST be installed by an Invacare

Dealer or technical personnel.

INSTALLATION WARNINGS

After ANY adjustments, repair or service and

BEFORE use, make sure all attaching hard-

ware is tightened securely - otherwise injury

or damage may occur.

Use proper lifting techniques to avoid in-

jury. Keep back straight and bend knees

when lifting components of the bath lift.

REPLACING THE PENDANT/CABLE/

CURRENT LIMIT DEVICE

NOTE: Refer to the INSTALLATION WARNINGS in the

SAFETY SUMMARY of this instruction sheet.

Removing the Seat (FIGURE 1)

WARNING

To prevent pinching injury between seat

back and motor shroud when removing/

installing the seat, DO NOT grasp seat any-

where other than at the recess at the top

(DETAIL "C"), the opening at the bottom of

the seat or the lip at the top of the seat.

To prevent frame from tipping when remov-

ing seat, either suction the frame to the floor

or place one foot on the frame base when

removing/installing the seat.

CAUTION

The bath lift seat MUST be removed from the

top of the lifting cycle, otherwise, damage

to the unit may occur.

DO NOT grasp seat by side flaps, otherwise

damage to the bath lift or the bathtub may

occur.

Reliant Bath Lift (RBL250)

Pendant/Cable/Current Limit Device Replacement Kit

Assembly, Installation and Operating Instructions

Kit No. 1085144

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - Reliant Bath Lift (RBL250)

11. Secure the frame to the floor with the suction cups or bystanding on the frame base during removal of the seat.2. Press the UP button on the penda

Page 2

2FIGURE 2 - REMOVING THE FRAME FROMTHE BATHTUBTILT FRAMEFORWARDSFrameBathtubSuction CupLoopSuctionCupSelf-LockingScrews(STEP 2)Mounting Screw(STEP 2)W

Page 3

3Removing the Battery Connector (FIGURE 5)1. Remove the two (2) mounting screws and nutssecuring the battery connector to the motor shroudas shown in

Page 4 - (FIGURE 6)

4Installing the Battery Connector (FIGURE 7)CAUTIONThe BLUE (-) and YELLOW (+) wires MUSTbe installed properly, otherwise, seriousdamage to the electr

Page 5

51. Connect the spade connector wires to the motorin the following manner:A. BLACK spade connector wire to lower spade.B. RED spade connector wire to

Page 6 - (FIGURE 9)

6Installing the Bath Lift into the Bathtub(FIGURE 9)WARNINGALWAYS lower the bath lift frame to thelowest position BEFORE performing thisprocedure. Oth

Page 7

7Installing the Seat (FIGURE 10)WARNINGTo prevent pinching injury between seatback and motor shroud when removing/installing the seat, DO NOT grasp se

Page 8 - LIMITED WARRANTY

LIMITED WARRANTYPLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAWAPPLICABLE TO PRODUCTS MANUFACTURED AFTER JULY 4, 1975.This

Commentaires sur ces manuels

Pas de commentaire

Invacare 1085144 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Communication Invacare 1085144. Invacare 1085144 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Communication Invacare 1085144