Invacare BUZZ HMV Manuel d'utilisateur télécharger pdf (Page 40)

40 Part No. 1118395

SECTION 8 BATTERIES

BATTERIES

7. Remove the EXISTING batteries from battery tray by lifting the batteries out in the

direction shown in DETAIL "A" of FIGURE 2.

8. Install two (2) NEW batteries into the battery tray.

9. Connect the wiring harness to the NEW batteries in the following order (DETAIL

"B" of FIGURE 2):

A. NEGATIVE (-) BLACK battery cable from the NEGATIVE (-) battery terminal/

post on the LEFT battery.

B. POSITIVE (+) RED battery cable to POSITIVE (+) battery terminal/post on the

RIGHT battery.

C. WHITE BATTERY CABLE (JUMPER) from the POSITIVE (+) battery terminal/

post on the LEFT battery and the NEGATIVE (-) battery terminal/post on the

RIGHT battery.

10. Connect the red and black battery connector to the wiring harness assembly.

Tighten securely.

11. Secure the batteries in the battery tray using the battery strap (DETAIL "A" of

FIGURE 2).

12. Reinstall the rear shroud. Refer to REMOVING/INSTALLING THE REAR SHROUD

in SECTION 7 of this manual.

13. Reinstall the seat. Refer to REMOVING/INSTALLING THE SEAT in SECTION 4 of

this manual.

NOTE: New battery(ies) MUST be fully charged BEFORE using, otherwise the life of the battery(ies)

will be reduced.

14. If necessary, charge the battery(ies). Refer to CHARGING BATTERIES in this section

of the manual.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Pas de commentaire

Invacare BUZZ HMV Manuel d'utilisateur Page 40