Invacare TRACER EX2 Manuel d'utilisateur télécharger pdf (Page 34)

SECTION 9—ANTI-TIPPERS/WHEEL LOCKS

Tracer® EX2 34 Part No. 1110546

SECTION 9—ANTI-TIPPERS/WHEEL LOCKS

 WARNING

After any adjustments, repair or service and before use, make sure all attaching hardware is

tightened securely. Otherwise injury or damage may occur.

Installing/Adjusting Anti-tippers

 WARNING

Anti-tippers are specific to the different seat-to-floor heights. Refer to the chart in this section of

the manual for correct usage and adjustment. If these requirements cannot be achieved, DO

NOT use the wheelchair. Contact a qualified technician. If changing the seat-to-floor height, the

correct anti-tippers MUST be used to maintain a 1

to 2 inch ground clearance.

If so equipped, anti-tippers MUST be attached at all times. Inasmuch as the anti-tippers are an

option on this wheelchair (You may order with or without the anti-tippers), Invacare strongly

recommends ordering the anti-tippers as a safeguard for the wheelchair user.

Anti-tippers MUST be fully engaged and release buttons fully protruding out of adjustment holes.

ALWAYS use anti-tippers. When outdoors on wet, soft ground or on gravel surfaces, anti tippers

may not provide the same level of protection against tipover. Extra caution MUST be observed

when traversing such surfaces.

Ensure both anti-tippers are adjusted to the same mounting hole.

NOTE:Forthisprocedure,refertoFIGURE 9.1onpage34andFIGURE 9.2onpage35.

Installing Anti-Tippers

NOTE:Toensurethecorrectmodelanti‐tipperisusedrefertoFIGURE 9.1.Measurementsforanti‐tippersareapproximateandare

takenwithextensiontubeinbottomholeposition.

FIGURE 9.1 Installing/Adjusting Anti-tippers - Anti-Tipper Length

1. Pressthereleasebuttonsandinserttheanti‐tipperswiththeanti‐tipperwheelspointingtowardtheground/floorinto

thewheelchairframetubingasshowninFIGURE 9.2.

WHEEL-

CHAIR

MODEL

SEAT-TO-FLOO

R HEIGHT IN

INCHES

ANTI-TIPPER (MEASUREMENTS IN INCHES)

LENGTH HEIGHT MODEL PART NO.

TRACER EX2 17½ to 19½ 13½ 3¼ 1360 1058836

TRACER EX2

FF 21 12 2¾ 9758 1086190

Anti-Tipper Height

Anti-Tipper Length

Flat Surface

Bottom Position

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40

Pas de commentaire

Invacare TRACER EX2 Manuel d'utilisateur Page 34